Filter
Top Products
52
Appendix
PC control
A computer can be used to control the projector by connecting an RS-232C cable (null modem, cross type, sold
separately) to the projector. (See page 17 for connection.)
Communication conditions
Set the serial port settings of the computer to match that of the table.
Signal format: Conforms to RS-232C standard.
Baud rate: 9,600 bps
Data length: 8 bits
Parity bit: NON
Stop bit: 1 bit
Flow control: None
Basic format
Commands from the computer are sent in the following order: command, parameter, and return code. After the
projector processes the command from the computer, it sends a response code to the computer.
RS-232C Port Specifications
Return code (0DH)
C1 C2 C3 C4 P1 P2 P3 P4
Response code format
Normal response
O K
Return code (0DH)
Problem response (Failure due to incorrect command/parameter or the other communication errors)
E R R
Return code (0DH)
Command 4-digit Parameter 4-digit
Command format
When more than one code is being sent, send each command only after the OK response code for the previous
command from the projector is verified.
• When using the computer control function of the projector, the projector operating status cannot be read to the computer.
Therefore, confirm the status by transmitting the display commands for each adjustment menu and checking the status with
the On-screen Display. If the projector receives a command other than a menu display command, it will execute the com-
mand without displaying the On-screen Display.
Commands
EXAMPLE
• When INPUT SWITCHING is set to INPUT 1 (DVI).
→
←
IRGB _ 1__
OK
ProjectorComputer
• If an underbar (_) appears in the parameter column, enter a space.
P
P
I
I
I
I
I
O
O
R
R
R
V
V
W
W
G
G
G
E
E
R
R
B
B
B
D
D
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
_
0
1
1
2
3
1
2
POWER OFF (STANDBY)
POWER ON
INPUT1 (DVI)
INPUT1 (RGB)
INPUT1 (COMPONENT)
INPUT2 (S-VIDEO)
INPUT3 (VIDEO)
INPUT SWITCHING
POWER SETTING
CONTROL ITEM
COMMAND
C1 C2 C3 C4 P1 P2 P3 P4
PARAMETER
CONTROL
CONTENTS