Filter
Top Products
Configuring Client TCP/IP
12
Subnet Mask: 255.255.255.0
Note: These settings may be changed to suit your network
requirements, but you must first configure at least one
computer as described in this chapter to access the
Barricade Router’s Web configuration interface.See
“Configuring the Barricade Router” on page 25 for
information on configuring the Barricade Router.)
If you have not previously configured TCP/IP for your computer,
refer to“Configuring Client TCP/IP” on page 9. The IP address of
the connected client PC should be 192.168.2.x (where x means
2–254). You can set the IP address for client PCs either by
automatically obtaining an IP address from the Barricade
Router’s DHCP service or by manual configuration.
Configuring Your Computer in Windows 95/98/Me
You may find that the instructions here do not exactly match your
version of Windows. This is because these steps and
screenshots were created in Windows 98. Windows 95 and
Windows Millennium Edition are very similar, but not identical, to
Windows 98.
1. From the Windows desktop, click Start/Settings/Control
Panel.
2. In the Control Panel, locate and double click the Network icon.