Filter
Top Products
36
Each machine can be programmed to enable the Compulsory Cash/Check Declaration (CCD) function. This
function compels the operator to enter the cash/check amount in the drawer just before either an individual
clerk/cashier Z report or a general Z report is printed.
To take a general Z report in case of compulsory CCD function, the following two conditions are applied.
1) If the CCD DATA is not entered in the master and the master is included in appointment of machine
number, all consolidation report at X1/Z1 mode is not executed.
2) If the CCD DATA is not entered in the satellite, all consolidation report is not executed.
In the case of the individual clerk file system, you need not make any CCD entry at the master before
generating a consolidated report. The generated report will include consolidated data on CCD entries which
have been made to generate individual reports.
Unless CCD entries have been made at the master and all the satellites in the IRC system to generate
individual reports, you can not generate a consolidated report at the master.
You can not generate some types of reports according to the table below. (For further details on this
function, see the UP-820F/UP-820N Instruction Manual.)
List of consolidated reports in the case of the individual clerk file allocation system (at the master)
• For further details on each CCD entry, see the UP-820F/UP-820N Instruction Manual.
• For choosing a type of compulsory cash/check declaration, please consult your authorized
SHARP dealer.
NOTE
: Report generation is not allowed.
: Report generation is allowed.
* : CCD entries at the generation of corresponding individual reports at the master and all the satellites must have
been done beforehand.
Type of report
CCD entry programming
Clerk/Cashier
Individual clerk/cashier report
General report Other reports
X
Non-compulsory
By clerk/cashier
By terminal (per shift)
*
Z X
*
ZXZ
7. Reports that can be generated when the Compulsory
Cash/Check Declaration (CCD) function is enabled