Filter
Top Products
47
For connection of a remote printer to a terminal(s) in the IRC system, be sure to consult your authorized
SHARP dealer.
(1) Basic programming for the remote printer – master and satellite
With the following procedure, you can do basic programming for the remote printer(s) included in the
IRC system.
For initial setup of the remote printer, please consult your authorized SHARP dealer.
1. Enter the PGM2 mode from the mode selection window.
2. Select “SETTING” and press the
e
key.
The SETTING window will appear.
3. Select “DEVICE CONFIG” and press the
e
key.
The DEVICE CONFIG window will appear.
4. Select the remote (kitchen) printer to be programmed.
5. Carry out the programming for the remote printer.
(See the next page for programming for individual remote
printer items.)
• Be sure to consult your authorized SHARP dealer for the
correct settings.
6. After programming for the remote printer, press the
c
key.
8. Programming for the remote printer