Filter
Top Products
38
For easier programming for the direct PLU keys, the register especially allows you to program all parameters in
one procedure according to guidance messages displayed on the upper line of operator display, while you can
program parameters individually. (For these individual programming methods, please refer to next two sections
and “PLU text (item label)” on page 44.)
Follow the procedure shown below for direct key programming:
• To keep current setting on each programming, press the
s
key when the corresponding
guidance message is firstly displayed.
• When pressing the
A
key in the middle of procedure, the programming will terminate and the
data you entered before the press of
A
is saved.
1. Specify the direct PLU key and its level.
2. Text programming (Press
s
to skip)
3. Unit price programming (Press
s
to skip)
ENTER DEPT#
0071 01
s
• Press the
s
key to register the unit price.
Guidance message for the next step will be displayed.
PRICE
0071 500
500
• Enter a unit price using numeric keys.
A maximum of 6 digits can be set.
For a subdepartment, set the limit amount of unit
price entry.
PRICE
0071 0.00
s
• Press the
s
key to register the item name.
Guidance message for the next step will be displayed.
Overwritten by new data
MELON PGM
0071 05
MELON
• Enter an item name.
A maximum of 16 characters can be entered.
Please refer to “Guidance for text programming” for
entering the item name.
When you start entering a character, the current text
data will be overwritten by new data.
Current text data
PLU.0071 PGM
0071 0.00
:
• Press
:
key to enter text programming.
The text data currently set will be displayed on the
upper line.
Guidance message
ENTER[00]KEY
0071 0.00
PLU code
PLU.0071 PGM
0071 0.00
[¡
• Press a level shift key and a direct PLU key in this
order.
Immediately after displaying the current text setting,
guidance message for the next step will be displayed
on the upper line and the corresponding PLU key
code you entered will be displayed on the lower line.
When you press a direct PLU key without pressing a
level shift key, level 1 is automatically selected.
Operator displayKey operation
A212_3 FOR THE MANAGER 03.7.5 8:02 AM Page 38