Filter
Top Products
Operation
E-12
Basic Operations
g. Selecting the Video Input System
Mode
The video input system mode is set to “AUTO”
at the factory; however, it can be changed to a
different system mode, if the selected system
mode is not compatible with the connected
audiovisual equipment (such as when a color
image appears in black and white, etc.).
1. Press MENU to display the menu screen. Press
ADJUSTMENT ∂/ƒ to select “IMAGE ADJ.”
Then press ENTER to display the “IMAGE ADJ.”
screen.
2. Press ADJUSTMENT ∂/ƒ to select “SYSTEM”.
Then press ENTER to display the “SYSTEM”
screen.
3. Press ADJUSTMENT ∂/ƒ to select the desired
video system mode. Then press ENTER.
• In AUTO mode, “PAL”, ”SECAM”, “NTSC 4.43” or “NTSC
3.58” is displayed on the screen for a few seconds when
the system mode is changed using INPUT SELECT on
the projector.
• When the system mode is set to “AUTO”, you may not
receive a clear picture due to signal differences. Should
this occur, switch to the color system you are viewing.
h. Selecting the Input Mode
1. Press INPUT SELECT on the projector to select
the input mode. When you press the button, the
current input mode will be displayed on the
screen for 4 seconds. If you press it again while
the input mode is displayed, the mode changes
as shown on the left.
• The input mode can be selected by directly pressing
COMPUTER or VIDEO on the remote control. (When
COMPUTER is pressed, “RGB1” and “RGB2” will appear
accordingly.)
2. Press INPUT SELECT on the projector to con-
firm the selected input mode.
• In VIDEO mode, the video system being received will be
indicated below the “VIDEO” display.
• In RGB mode, the resolution being displayed will be indi-
cated below the “RGB1” or “RGB2” display.
• When no signals are being received, “NO SIGNAL” will
be displayed. When a signal that the projector is not pre-
set to receive is being received, “NOT REG.” will be dis-
played.
• The picture size differs in “RGB”, “PAL”, “SECAM” and
“NTSC” modes.
VIDEO ADJ.
BACKGRND LVL
IMAGE ADJ.
AUDIO
SYSTEM SETUP
LANGUAGE
:SEL. :NEXT
ENTER
:END
MENU
:SEL. :NEXT
ENTER
:END
MENU
BLUE SCREEN
BLK SCRN DISP
IMAGE ADJ.
REVERSE
INVERT
INPUT DISPLAY
[
OFF
]
[
OFF
]
[
OFF
]
SYSTEM
[
OFF
]
[
ON
]
g.1 g.2
g
AUTO
SYSTEM
PAL
SECAM
NTSC 4.43
NTSC 3.58
:SEL. :ENTER
ENTER
:END
MENU
g.3
On-screen Display
h
Mac
To view the image
from a source
connected to:
VIDEO INPUT
COMPUTER INPUT 1
COMPUTER INPUT 2
XG-NV4SU (E)-b 98.10.19, 5:35 PM12