Filter
Top Products
MP 595 Modem User Guide
Note: You must be logged in
with administrative privileges to
install the software.
I/O port connections
The MP modem’s I/O port is a standard female DB15HD
connector for remote monitoring of gauges, sensors, and
alarms. If you are planning to use these devices, you need to
create a custom I/O cable. See “Configuring the MP Modem to
Report GPS and I/O Data” on page 41.
Step 5—Install the software
Follow these steps to install 3G Watcher and the MP modem
driver:
1. Ensure that the computer has the necessary system
requirements. (See “System requirements” on page 22.)
2. Close any Windows applications that are open on your
computer.
3. Insert the MP modem CD in your CD-ROM drive.
The CD should automatically launch and display a menu.
If not, select
Start > Run from the Windows taskbar and
type
d:\setup.exe (where d is the drive letter of your
CD-ROM drive).
4. From the CD start-up menu, select
installation and
documentation
and then MP 3G Watcher installation to launch
the Installation Wizard.
5. Use the
Next and Back buttons to navigate through the
wizard.
6. Click
Finish in the final window. To close the CD start-up
menu, select the taskbar button to re-display the window,
then select
exit in the lower right corner of the window.
7. Power on the MP modem and connect it to your computer.
Windows then completes driver installation.
Step 6—Activate your account
After you install the 3G Watcher software, you must set up
(activate) your account. If you purchased the MP 595 modem
directly from a service provider you may already have an
account; your MP modem may be pre-activated.
The MP 595 modem allows you to configure two accounts.
The Activation Wizard
The Activation Wizard guides you through the process of
setting up your account.
There are two methods of activation:
34 2130795