Filter
Top Products
3-3
Users Manual CX2
PRICOM User Software CX2
How to Communicate to the PRICOM C-6400W
Procedure for initial communication with the PRICOM C-6400W
The following explains how to initially communicate with the PRICOM C-6400W until the
wireless parameters are configured.
- 802.11 Ad hoc mode
The PC's wireless parameters must match the PRICOM C-6400W's.
Change the PC's wireless settings to match the default settings of the PRICOM C-6400W
which are:
Mode : AdHoc mode (802.11 Ad hoc mode)
SSID : GROUP
Channel : 11
WEP : (none)
- Infrastructure mode
The PRICOM C-6400W's wireless mode can be changed to Infrastructure by using the push
button. The PC's wireless settings and an access point will still need to match the default
settings of the PRICOM C-6400W.
- Refer to 2, PRICOM C-6400W - Start in Infrastructure mode for instructions on how to change
to infrastructure mode.
- If you configure to infrastructure mode, do not use WEP in your access point.
- If you cannot connect to the PRICOM C-6400W, initialize to factory default and try again.