Filter
Top Products
10Appendix
Users Manual SX
Tab
Factory
Default
NDS Tree
Name
Specify the name of the NDS tree
connected to. Because the tree name is
obtained automatically, it is usually
unnecessary to specify it here. When there
are two or more trees on the same network
it is necessary to specify the name here.
-
NDS Context Specify the NDS context connected to in
PSERVER mode. The context which
created the print server on the file server
should be specified here.
-
NetWare Print
Server to be
connected
Set the name of the print server primarily
connected to. This product connects to the
print server set here when operating in
RPRINTER mode. This product searches
print server automatically and connects if
the value is blank.
-
Job Timeout Set the timeout value (in units of seconds)
for the print server to determine the end of
the job when operating in RPRINTER mode.
Usually the value should be the default.
10
PRxxxxxx-Prn1
(Lower 6 digits
of Ethernet
address)
Job management can be performed via NetWare server.
NDS Setup
Item
Printing Method
NetWare
Set the printer name under print server information within the
NetWare server. It must be the same as the "Printer Name"
registered in the NetWare server.
Printer Name
RPRINTER Setup
Explanation
RPRINTER
PSERVER
Printing method