Filter
Top Products
11
ht5000
Initialisation
Status
Led blue
Led red
Standby
On
Cooling
: O
: On
: Flashing
Error (*)
Logo Backlit
Blue Color
Red Color
O / Blue Color (*)
Red Color
Red Color
6 CONNECTIONS
To obtain the best performance from your projector, we recom-
mend the use of good quality “video cables” to the various
signal sources (75 ohm Impedance).
Poor quality cables will cause inferior picture performance.
For optimum connectivity we recommend you follow these
simple steps:
With exception of coaxial RCA/Phono type connectors,
always double-check that the plug is inserted the correct
way round to avoid damaging the plugs or the sockets on
the projector.
Remove cables by the plug and do not pull on the cable
itself. Avoid tangled cables.
Position the cables carefully to avoid a trip hazard espe-
cially in low light areas.
Fig. 11
LED SYSTEM TABLE
(*): IN CASE OF ERROR, CONTACT YOUR LOCATE AND AUTHO-
RIZED SIM2 DEALER FOR SERVICE INFORMATION.
TO DIAGNOSE THE PROBLEM IT MUST COMUNICATE TO ASSI-
STANCE THE FALSHING NUMBER OF RED LED.