Filter
Top Products
Installation Drive Configuration
28 Zeus Ultra DMA Solid State Drives
3.2.1 Configuring 2.5-inch Form Factor Zeus SSD
Zeus SSDs conforming to the 2.5-inch form factor, use a 44-pin ATA bus connector. To
configure the SSD as either the Master or Slave device, place a jumper across the
appropriate pins (A-D) as illustrated in Figure5 on page28.
Figure 5. Master/Slave Setting for 2.5-inch Zeus SSDs
In systems with multiple drives, it may be necessary to configure disk
storage in a Master/Slave configuration. To accomplish this, boot the
computer using IDE HDD Auto Detection available in the CMOS setup.