Filter
Top Products
The following table describes the power state fields:
Field Description
Powering The projector is turning on.
On The projector is on.
Cooling The projector is cooling.
Confirm off Confirm off is a non-selectable power state that is returned during
stage one of the two-button Off sequence.
Idle The projector is off but still receiving power (Standby mode).
Source selection controls
These commands switch input sources. The source type determines which commands can be
accepted.
Command Response Available in Standby
mode
get input input=[field] Yes
set input=[field] input=[field] No
The following table describes the source selection commands:
Command Description
get input Returns the projector’s current input.
set input=[field] Sets the input to one of the selectable fields.
The following table describes the source selection response fields:
Field Description
VGA1 Switches source to the VGA 1input connector.
VGA2 Switches source to the VGA 2input connector.
Composite Switches source to the Composite video connector.
If you installed your interactive whiteboard system according to the
instructions, this is the relay from the ECP.
S-Video Switches source to the S-Video input connector.
HDMI Switches source to the HDMI input port.
None A non-selectable value that appears when you enter a “get input”
command while the projector is in Standby mode.
General source controls
The following source controls apply to all input sources. HDMI connector source controls are
described in this section. These controls are unavailable when the projector is in Standby mode. You
can specify custom color values for all inputs.
These commands inform you of the current source settings.
A PPEND IX B
Remotelymanagingyour systemthrough anRS-232serialinterface
76