Filter
Top Products
10 Installing the Interactive Whiteboard 99-00667-00 B0
7. Attach the second hanger bracket in the same way.
8. Place the mounting bracket over the flat-panel display with the left hanger bracket on your
right side. The left bracket goes on your right because you are looking at the back of the
flat-panel display. The hanger brackets should face towards the flat surface so that the
horizontal section of each bracket makes a U-shape, as shown in the figure below.
9. Using the supplied Installation Template as a guide, align the slotted holes in the mounting
bracket with the adapter plate bolt holes in the flat-panel display.
CAUTION
If the mounting bracket is mistakenly installed upside-down, the hanger
brackets won’t be able to support an overlay and the installation will be unsafe.
IMPORTANT
Obtain the best possible alignment before mounting either the flat-panel
display or the overlay. After you mount the overlay, you’ll be limited in how
much you can move the overlay relative to the flat-panel display. If the overlay
is aligned poorly, it obscures some of the flat-panel display’s screen.
CAUTION
Try not to position the mounting bracket over the flat-panel display’s cooling
vents. Blocking these vents could cause overheating and damage to the
flat-panel display.
Mounting Bracket
Center Section
Both hanger brackets
make a U-shape
Left hanger bracket
is on the right side
(when viewed
from the back)
33
1
Position Unive rsal Bracket
between lines and
AB
Note:
If your plasma panel has 8 mounti ng holes, 2 mounting
options may exist. Use the option which does not obscure
adjacent mounting holes.
Align the top of the universal bracket with line A.
4
Ensure the bracket is centred left to right on the plasma panel.
Finish installing the PX350 as per your instruction manual.
Slide the universal bracket up the plasma panel, l ooking
through the slotted holes for the top mounting points on the
back of the plasma panel. Do not pass line B.
2
Align the top right corn er of this te mplate with th e face down
plasma panel as shown below.
Do not pass this line
1
PX350 Installation Template
© 1997-2005 SMART Technologies Inc. All rights reserved. Expression and the SMART logo are trademarks of SMART Technologies Inc. 99-00617-00-A0
Installation Template