Filter
Top Products
C
ONFIGURING
THE
S
WITCH
2-14
Web – Click System, IP. Specify the Management VLAN, and set
the IP Address Mode to DHCP or BOOTP. Click Apply to save your
changes. Then click Restart DHCP to immediately request a new
address. Note that the switch will also broadcast a request for IP
configuration settings on the each power reset.
Note: If you lose your management connection, use a console
connection and enter “show ip interface” to determine the
new switch address.
CLI – Specify the management interface, set the IP Address Mode
to DHCP or BOOTP, and then enter the “ip dhcp restart”
command.
Console#config
Console(config)#interface vlan 1 3-89
Console(config-if)#ip address dhcp 3-80
Console(config-if)#end
Console#ip dhcp restart 3-81
Console#show ip interface 3-83
IP address and netmask: 10.1.0.3 255.255.255.0 on VLAN 1,
and address mode: Dhcp.
Console#