Filter
Top Products
2 | Hardware Preparation
Charging and Installing the Battery
1. The battery must be charged before initial use,
using the included Socket charger. The
Charging LED will be yellow during charging.
After approximately 4 hours, the battery will
reach full charge, indicated by a green Charging
LED.
Do not use the charger with other types of batteries. A
fully charged battery should provide at least 10,000
scans and more than 8 hours of operation.
Battery Charger LEDs
LED LED Activity Meaning
Power Red Plugged into valid power source
Yellow Charging
Charging
Green Battery is fully charged
You can also check the battery level by checking the CS HW screen of the
SocketScan settings utility. The utility will report the battery level only when the
CRS is connected to your mobile computer.
2. Slide the switch at the bottom of the wrist unit to unlock the battery door.
Insert the battery so that the battery contacts align with the contacts
inside the wrist unit, then close and lock the battery door.
WARNING: Do not insert the battery backwards or upside-down.
Damage may result.
CHAPTER 2: HARDWARE PREPARATION 11