Filter
Top Products
Assembling and Putting on the CRS
You can put on the CRS either with or without the case. If you choose not to
use the case, the plastic parts of the wrist unit will be more susceptible to
abuse.
How to put on the CRS with the wrist unit case
1. Insert the wrist unit into the case, pulling the free end of the cable
through the hole in the top of the case. During insertion, you may hear a
beep and see the LED flicker because the power button was pressed,
however, the wrist unit will not turn on unless the button was pressed for
more than 2 seconds, and the LED continues to blink.
2. Connect the free end of the cable to the ring scanner.
3. Attach the finger strap to the bottom of the ring scanner. To insert the
clips, grasp it with the thumb and index finger. Insert one end of the clip
post into the slot, gently push down, and then push the other end of the
post in for a snug fit. To remove the finger strap, grasp the clips with the
thumb and index finger then pull one side of the clip out and remove. Do
not twist the clips upon insertion or removal—this may cause the
clips to break.
4. Put on the wrist strap. Adjust it for a secure and comfortable fit.
5. Put the ring scanner on your index finger, adjusting the finger strap for a
secure and comfortable fit.
12