Filter
Top Products
Additional functions
You can assign any of the following functions to the F
key: Count, Hold, Unit switch.
The standard function
is Count. You can make changes in User mode (p.
18/19).
Count
When Count mode is active: Press the key.
The reference items to be placed on the scale are
displayed.
Pressing the
key again increments the amount of
reference items in the following steps: 1/2/5/10/25/50.
Place the items on the scale in accordance with the
specifications.
Confirm this by pressing the key.
Place the required amount of items on the scale.
Read-off the amount.
To switch to items with a different reference weight,
press the key again.
To switch to Weigh mode, press the key.
Hold function
When this mode is active, press the key. "Hold"
flashes until the value is determined and frozen.
These 6 modes are sett
able in User mode:
kg/lb switch (with non-calibratable units)
Your service partner can activate 2 different func-
tions:
Assignment of the F key to switch unit
s.
(On restarting, the most recently chosen unit is
displayed).
General restriction to kg or lb (F key can be assigned
to Count or Hold).
Mode Hold Remove by pressing
Manual At a standstill outside
the zero range
key
Automatic Remove load from scale
Slave pointer,
manual
For weight increase
and repeated standstill
key
Slave pointer,
automatic
Remove load from scale
Maximum value,
manual
of the maximum
weight reached
(without being at a standstill)
key
Maximum value,
automatic
Remove load from scale
17
ENGLISH
Ba_2790_D_GB_F_E_I.qxd 14.06.2006 08:28 Seite 17