Filter
Top Products
Page 28 Appendix B: Safety Instructions and Regulatory Information
Appendix B: Safety Instructions and Regulatory
Information
Regulatory Model/Type Product Name
APL17-049 TZ 180 Wireless
Mounting the SonicWALL
• Mount in a location away from direct
sunlight and sources of heat. A maximum
ambient temperature of 104º F (40º C) is
recommended.
• Route cables away from power lines,
fluorescent lighting fixtures, and sources
of noise such as radios, transmitters, and
broadband amplifiers
• The included power cord is intended for
use in North America only. For European
Union (EU) customers, a power cord is not
included.
• Ensure that no water or excessive
moisture can enter the unit.
• Allow unrestricted airflow around the unit
and through the vents on the side of the
unit. A minimum of 1 inch (25.44mm)
clearance is recommended.
• Consideration must be given to the
connection of the equipment to the supply
circuit and the effect of overloading the
circuits has minimal impact on overcurrent
protection and supply wiring. Appropriate
consideration of equipment nameplate
ratings must be used when addressing
this concern.
Lithium Battery Warning
The Lithium Battery used in the SonicWALL
security appliance may not be replaced by the
user. Return the SonicWALL security appliance
to a SonicWALL-authorized service center for
replacement with the same or equivalent type
recommended by the manufacturer. If, for any
reason, the battery or SonicWALL security
appliance must be disposed of, do so following
the battery manufacturer's instructions.
Cable Connections
All Ethernet and RS232 (Console) cables are
designed for intra-building connection to other
equipment. Do not connect these ports directly
to communication wiring or other wiring that
exits the building where the SonicWALL is
located.
Power Supply Information
If the power supply is missing from your
SonicWALL product package, please contact
SonicWALL Technical Support at 408-752-7819
for a replacement. This product should only be
used with a UL listed power supply marked
“Class 2” or “LPS”, with an output rated 12 VDC,
minimum 1.66 A.