Filter
Top Products
13
Getting started
To return the Access Point settings to the factory default settings
To return the Access Point settings to the factory default settings, hold
down the factory default switch for approximately one second while the
power of the Access Point is ON. For information on the location of the
factory default switch position, see “Names of parts and functions” on
page 9.
About the indicator display
When you press the factory default switch, the MESSAGE indicator flashes
orange. If you continue to press this switch, the WIRELESS, NETWORK
1, and NETWORK 2 indicators flash green, and the operation to return the
Access Point settings to the factory default settings begins. When the
indicators stop flashing, the Access Point settings have been returned to the
factory default settings. For setting details, see page 12.
Note
If you perform this procedure, all previously set data will be lost.
MAC address
You can check the MAC address for the Access Point NETWORK 1
connector on the Status Display screen. For details, see “Confirming the
status of the Access Point” (page 21).