Filter
Top Products
10 Location and Function of Parts
m SWITCHER GPI (Switcher General Purpose
Interface) connector (D-sub 25-pin)
Connect to external devices for input and output of trigger
signals. Up to eight inputs and eight outputs are possible,
with input and output conditions set on the center control
panel.
n TERMINAL connector (D-sub 9-pin, RS-232C)
This connetor is used for factory adjustments.
o U (signal ground) terminal
Connect to the system ground.
p - AC IN (AC power input) A, B, C, D connectors
(3-pin)
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
Depending on the system’s configuration when shipped,
there may be no optional HK-PSU04 Power Supply Units
installed. In that case, the AC IN C and D connectors is not
used.
Caution
For information about installing an HK-PSU04, contact
your Sony service representative.
q OUTPUTS 1 to 48 connectors (BNC type)
(BKDS-9160)
These connectors output serial digital signals. They can be
freely assigned to program output, preview output, AUX
output and so on.
There are two BNC connectors for the lower numbers on
each slot (1 to 4, 13 to 16, 25 to 28, 37 to 40) and one BNC
connector for the upper numbers (5 to 12, 17 to 24, 29 to
36, 41 to 48).
Make output assignments using the center control panel of
the DVS-9000 system.
The number of connectors varies depending on the number
of BKDS-9160 sets installed.
Refer to the User’s Guide for information about signals
that may be assigned.
r PRIMARY INPUTS 1 to 68 connectors (BNC type)
(MKS-8110SD)
These connector accept up to 68 serial digital video signal
inputs. The number of connectors varies depending on the
number of MKS-8110SD boards installed.
s EXTEND INPUTS 69 to 80 connectors (BNC type)
(MKS-8111SD)
These connectors accept up to 12 expansion serial digital
video signal inputs.
Use these connectors when 69 or more inputs are required.
t MONITOR OUTPUTS 49 to 56 connectors
(BNC type) (BKDS-9161)
Use these connectors as outputs for primary input monitors
or as auxiliary outputs for external devices.
These connectors are effective if you wish to output
primary inputs with as little delay as possible.