Filter
Top Products
17
Connecting the Projector
Projecting the Picture
Connecting the
Projector
When you connect the projector,
make sure to:
• Turn off all equipment before making any
connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose
connections may increase noise and
reduce performance of picture signals.
When pulling out a cable, be sure to pull it
out by the plug, not the cable itself.
When connecting to a LAN using a LAN
cable, see “Operating Instructions for
Network” stored on the CD-ROM.
This section describes how to connect the
projector to a computer.
For more information, refer to the
computer’s instruction manual.
To connect a computer (Analog)
A Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
B HD D-sub 15-pin cable (not supplied)
• The projector accepts VGA, SVGA, XGA,
WXGA, SXGA, SXGA+ and UXGA
signals. However, we recommend that you
set the output mode of your computer to
SXGA+ (VPL-FE40) or XGA (VPL-FX40)
mode for the external monitor.
• If you set your computer, such as a notebook
computer, to output the signal to both your
computer’s display and the external monitor,
the picture of the external monitor may not
appear properly. Set your computer to output
the signal to only the external monitor.
Connecting a Computer
Notes
Side
to monitor output
Computer
to audio output