Filter
Top Products
21
Turning Off the Power
Projecting the Picture
To adjust the tilt of the installation
surface
If the projector is installed on an uneven
surface, use the adjusters to keep the
projector level.
• Be careful not to let the projector down on
your fingers.
• Do not push hard on the top of the projector
with the adjuster extended.
It may cause a malfunction.
Turn ing Of f the
Power
1 Press the ?/1 key.
“POWER OFF? Please press ?/1 key
again.” appears to confirm that you want
to turn off the power.
The message disappears if you press any
key other than the ?/1 key, or if you do not
press any key for five seconds.
2 Press the ?/1 key again.
The ON/STANDBY indicator flashes in
green and the fan continues to run to
reduce the internal heat. Also, the ON/
STANDBY indicator flashes quickly.
During this time, you will not be able to
light up the ON/STANDBY indicator
again with the ?/1 key.
3 Unplug the AC power cord from the
wall outlet after the fan stops running
and the ON/STANDBY indicator
lights in red.
When you cannot confirm the on-
screen message
When you cannot confirm the on-screen
message under certain conditions, you can
turn off the power by holding the ?/1 key for
about one second instead of the steps 1 and
2 above.
The internal circuitry of the Off & Go and
Direct Power On/Off functions may cause the
fan to continue to operate for a short time even
after the ?/1 key is pressed to turn off the
power and the ON/STANDBY indicator
changes to red.
Notes
Turn to
adjust
Adjusters
Note
Note