Filter
Top Products
34
FWD-S42H1
Community
(4)
Command
(4)
Data
(n)
Header
(2)
0
0
Version (8) Category (8)
1 (Bit position)
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5
2. Setting Items
The items that can be set to ID Talk are shown in the table below.
Item Description
Start ID Talk Service Select the check box when using ID Talk. Clear the check box when using no ID Talk.
(default setting: OFF)
Port No. Changes the port number. A port number have to change port number 53484 cannot
be used because it has been already used for another purpose.
Timeout Specify the timeout time of connection.
Connection is automatically disconnected when communication is not done for the
specied time.
IP address of client Executes only the request from the specied IP address.
(Host Address) ID Talk does not have the security function such as user authentication. During
installation, safety can be improved by setting this item.
Multiple host addresses can be set.
Community Changes the community of a header. Four (upper-or-lower case) alphanumeric
characters can be set.
(default setting: SONY)
Set the items described above properly on the SETUP → ID Talk page of the Web page when using ID
Talk.
3. Packet Structure
The packet structure of ID Talk is described below.
Packet structure
3-1. Header
The header is constituted by two bytes consisting of a version (8 bits) and category (8 bits).
Header structure
Version
Indicates the version number of an ID Talk protocol.
This version is xed to 02h (version 2).
Category
Contains the category number of display equipment to be controlled. A category number is conrmed on
the display equipment side. A request is ignored when a different category number is contained.
Code Category
10h Information Display