Sony ICF-SC1PC Scanner User Manual


 
bother
useful functions
SKIP
function
You can designate any frequency as a SKIP-frequency (up
to
100).
The receiver will skip this frequency during
scanning. Designate any unwanted frequency
(interference signals, etc.) as a SKIP-frequency.
Designating a SKIP-frequency
1
If you are in the Scanning Mode, press SCAN to enter
the Manual Mode.
m
will disappear from the display.
2
Tune in, by any way, to a frequency you wish to
specify as a SKIP-frequency.
3
Press SKIP.
The frequency is designated as a SKIP-frequency.
To cancel SKIP designation
Press SKIP again.
SKIP-frequency designation is effective for any of the Scanning
Modes.
To display the SKIP-frequencies
Press +/- while holding down SKIP.
The SKIP-frequencies will be displayed one by one in
ascending/descending order.
When there is no SKIP-frequency, the following display will
appear momentarily, and then the receiver will return to the
previous status.
El
no
SKIP
Note
You can designate up to 100 SKIP frequencies. If you try to
designate a SKIP-frequency when there is already 100, the
following display will appear momentarily, and then the receiver
will return to the previous status.
In this case, cancel a previously designated SKIP-frequency first.
28