Filter
Top Products
Adjusting scanning pause
time
DELAY
DELAY is turned on by default.
DELAY is indicated in the display, and scanning will not
restart unless there is a reception break of 2 seconds.
This is convenient, for example, when receiving a 2-way
transmission, where there is a short break between the
transmission.
To cancel DELAY
Press PRI/DELAY for 1 second or longer. DELAY will
disappear, and the receiver resumes scanning the moment
signal reception is broken during scanning pause.
Press PRI/DELAY for 1 second or longer again to turn
DELAY on again.
Limiting scanning pause to 5 seconds
(5-second
pause mode)
1
2
If you are in the Scanning Mode, press SCAN to enter
the Manual Mode
(
a
disappears).
Press SCAN for 1 second or longer.
w
will be displayed and the decimal point of the
frequency display will flash.
Normally, the receiver will remain in scanning pause until
signal reception is broken or scanning is resumed
manually.
In the 5-second pause mode, the receiver will pause
scanning only for 5 seconds and automatically resume
scanning at every stop.
To cancel the 5-second pause mode
Press SCAN to return to the Manual Mode. Then press
SCAN lightly (less than 1 second) to re-enter the Scanning
Mode.
Notes
*You can run Programmable Scanning in the 5-second pause
mode by pressing SCAN for 1 second or longer while holding
down
ENTER.
*DELAY and the 5-second pause can be set individually.
*If the signal breaks in less than 5 seconds, the receiver resumes
scanning in 2 seconds (with DELAY on) or at that moment (with
DELAY off).
*If the signal is received for 5 seconds in the 5-second pause
mode, the receiver will resume scanning at that moment
regardless of the DELAY setting.
*To run Service Scanning in the 5-second pause mode, see
“Service Scanning”, page 17.
30