Filter
Top Products
8
-EN
Getting Started
COMPOMENT VIDEO OUT
S VIDEO OUT
LINE OUT
C
B/B-YYCR/R-Y
R-AUDIO-L VIDEO
CR/
R-Y
C
B/
B-Y
Y
L
R
1
L
(MONO)
R
2
3
LINE OUT
R-AUDIO-L VIDEO
Connecting a DVD player
C
Connecting an amplifier with Dolby* Pro Logic decoder
Even though you use an amplifier with Dolby Pro Logic
decoder instead of the projection TV’s audio system, you
can still use the projection TV’s center speaker.
* Manufactured under license from Dolby Laboratories
Licensing Corporation.
DOLBY, the double-D symbol a and “PRO LOGIC” are
trademarks of Dolby Laboratories Licensing Corporation.
Amplifier with Dolby Pro
Logic decoder
Rear
speaker
(L)
Rear
speaker
(R)
Front
speaker
(L)
Front
speaker
(R)
to (center speaker
inputs)
Rear of TV
Connecting a DVD player with component video output connectors
Notes
• Since the high quality pictures on a DVD disc contain a lot of
information, picture noise may appear. In this case, adjust the
sharpness (SHARP) in the VIDEO ADJUST menu. (See page 19.)
• Connect your DVD player directly to your TV. Connecting the
DVD player through other video equipment will cause unwanted
picture noise.
• If your DVD player can output interlace and progressive mode
signals, select the interlace output when connecting to
(component video input) on your TV.
Your TV can receive either 525i/60 Hz or 625i/50 Hz interlace
signals.
Rear of TV
: Signal flow
to audio/
video
outputs
DVD player
to … 1, 2, or 3 (video input)
(yellow)
-L (MONO)(white)
-R (red)
Rear of TV
: Signal flow
-L (white)
-R (red)
to (component video
input) Y/C
B
/B-Y/C
R
/R-Y
to component video
output
to audio output
DVD player