Filter
Top Products
16
Projecting an Image
2 Press the ENTER key.
The cursor appears.
3 You can adjust the deflection of the
side, using V/v/B/b.
You can adjust the center point of
deflection using B/b. For the range of
deflection, use V/v. You can adjust the
top/bottom independently.
The cursor will disappear if the
deflection range limit is reached.
Setting the blending function to
project from multiple projectors
1 Install the projectors.
Input a pattern, etc., to adjust the
projected positions from multiple
projectors.
Set a different ID mode for each
projector (page 25).
2 Enable the Edge Blending function.
Display the main menu to set “Edge
Blending” to “On” in the Installation
menu.
3 Set the position of blending.
Choose the position (top/bottom/left/
right) for blending.
4 Assign the blending width.
Set the blending width according to the
overlapping range for the source signal.
5 Adjust using “Zone Black Level Adj.”
Adjust using this cursor
Example of cursor display:
Adjust in all directions
Leftward, rightward or
downward adjustment only
Assign the position and width here.