Sony NT-2 Microcassette Recorder User Manual


 
Use only the AC-NT2 (U.S.A. model) or AC-E15HGS (U.K. model) AC
power adaptor (supplied). Do not use any other AC power adaptor.
The recorder is not disconnected from the AC power source as long as it is
connected to the wall outlet, even if the recorder itself has been turned off.
If you are not going to use this recorder for a long time, be sure to
disconnect the power supply (AC power adaptor, dry battery). To remove
the AC power adaptor from the wall outlet, grasp the adaptor plug itself:
never pull the cord.
The supplied AC power adaptor for this model is not available. If you need
this AC power adaptor, please consult your nearest Sony dealer.
Do not install the unit in a location near heat sources such as radiators or air
ducts, or in a place subject to direct sunlight, excessive dust, mechanical
vibration or shock.
Do not drop or hit the unit. Doing so may cause a malfunction in the unit.
Incorrect battery usage may lead to leakage of battery fluid or bursting
batteries. To prevent such accidents, observe the following precautions:
Install the + and – poles of the battery correctly.
Do not try to recharge the battery.
When the unit will not be used for a long time, be sure to remove the
battery.
If a battery leak should develop, carefully and thoroughly wipe away
battery fluid from the battery compartment before inserting a new one.
Batteries and metal should not be put together. If the + and – poles of the
battery touch metal, a short circuit may result.