Sony PCG-F370 Laptop User Manual


 
Owners Record
The model number and serial number are
located on the bottom of your Sony VAIO
®
Notebook. Record the serial number in the
space provided here. Refer to the model
and serial number when you call your
Sony Service Center.
Model Number: PCG-F370/PCG-F390
Serial Number:________________________
Safety Information
To prevent fire or shock hazard, do
not expose your notebook computer
to rain or moisture.
To avoid electrical shock, do not open
the cabinet. Refer servicing to
qualified personnel only.
Never install modem or telephone
wiring during a lightning storm.
Never install telephone jacks in wet
locations unless the jack is specifically
designed for wet locations.
Never touch uninsulated telephone
wire or terminals unless the telephone
line has been disconnected at the
network interface.
Use caution when installing or
modifying telephone lines.
Avoid using the modem during an
electrical storm.
Do not use the modem or a telephone
to report a gas leak in the vicinity of
the leak.
A socket outlet should be as close as
possible to the unit and easily
accessible.
Pour prévenir tout risque d’incendie
ou d’électrocution, garder cet appareil
à l’abri de la pluie et de l’humidité.
Pour prévenir tout risque
d’électrocution, ne pas ouvir le châssis
de cet appareil et ne confier son
entretien qu’à une personne qualifiée.
L’appareil doit être le plus près
possible d’une prise murale pour en
faciliter l’accès.
Regulatory Information
.
!
To change the backup battery,
please contact your nearest Sony
Service Center.
WARNING
!
For DVD-ROM: As the laser beam
used in the DVD-ROM drive is
harmful to the eyes, do not
attempt to disassemble the drive
cabinet. Refer servicing to
qualified personnel only.
AVERTISSEMENT
Declaration of Conformity
Trade Name: SONY
Model No: PCG-F370/PCG-F390
Responsible Party:
Sony Electronics Inc.
Address:
1 Sony Drive
Park Ridge, NJ 07656
Telephone No.: 201-930-6970
This device complies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device
must accept any interference
received, including interference
that may cause undesired
operation.