Filter
Top Products
Sony Notebook User Guide
Connecting peripheral devices
59
nN
4 Plug the cable attached to the AC adapter (1) into the DC In (2) connector on the port replicator (3).
5 Plug the power cord (4) into the AC adapter and an AC outlet.
The power indicator light turns green.
6 Turn on the computer.
✍
When you use the port replicator for the first time, the installation of the network drivers starts automatically.
When attaching your computer to the port replicator, do not attempt to insert or remove the battery pack. Lifting and turning the computer with the
attached port replicator may cause a temporary loss of power.
You do not need to use the floppy disk supplied with your port replicator.
Disconnecting your computer from the port replicator
To disconnect your computer from the port replicator, proceed as follows:
1 Turn off the computer and the connected peripherals.
2 Pull the levers on each side of the port replicator (1) to disconnect the computer from the port replicator.
3 Lift the computer away from the port replicator.