Filter
Top Products
Configuring Your System
21
VGA Switch
You can enable or disable the onboard VGA controller if you install a
VGA PCI add-in card.
To enable or disable the onboard VGA, perform the following steps:
1
Remove the system cover (see “Removing the System Cover” on
page 24).
2
Set the VGA switch (SW6) to ON (Enable) or OFF (Disable). The
default is ON (also see “Configuration Switches (SW)” on page 67).
3
Reinstall the system cover (see “Replacing the System Cover” on
page 25).
O
N
123456
KY0092.VS
D
VGA switch
O
N
123456
ON
OFF
SW