Filter
Top Products
PFV-SP3100
1-6 (E)
1-6. Rack Mounting
n
Install a ventilating fan in the rack to prevent the increase
in the temperature inside a rack when multiple units are put
in one rack.
1-6-2. Rack Mounting Procedure
Explains the procedure for rack mounting by Rack Mount
Kit RMM-10.
n
Fasten the screws at the tightening torque below.
Tightening torque: 1.2 N.m {12.2 kgf.cm}
1. Attach the rack brackets in the side panels of the unit
with the specified six screws.
n
Be sure to use B4x6 as a screw.
2. Loosen the screws at the rear of the each adaptor,
before adjusting each adaptor length to the rack depth.
(Following figure is case of left side.)
1-6. Rack Mounting
PFV-SP3100 can be mounted on a 19-inch standard rack
for use.
Mount PFV-SP3100 on the rack properly in the procedure
below using a specified rack mounting kit.
Specified rack mounting kit: RMM-10
n
PFV-SP3100 may not be able to be mounted on a 19-inch
standard rack using a rack mounting kit other than the
specified one.
Components of RMM-10
. Rack brackets ........................................................... 2 pcs
. Rack mounting adaptor (right) ................................. 1 pc
[Including two screws (B 4x6: 7-682-560-09)]
. Rack mounting adaptor (left) ................................... 1 pc
[Including two screws (B 4x6: 7-682-560-09)]
. Rack bracket fixing screws (B 4x6: 7-682-560-09)
.......................................................................... 6 pcs
. Adaptor fixing screws (B 4x10: 7-682-560-10) ...... 6 pcs
Required other parts
To mount the unit on the rack, the following parts are
required.
. Screws for rack mounting (B5x12: 7-682-576-04)
.......................................................................... 4 pcs
1-6-1. Notes on Rack Mounting
w
. Fix the rack on the horizontal and firm floor with bolts to
prevent it from turning over or moving.
If the rack overturn due to the weight of the unit, this
may cause a death or serious injury.
. After rack mounting, be sure to tighten the screws of the
rack angle and fix this unit to the rack.
If not, this unit may slide and fall from the rack. This
causes an injury.
c
Attention when this unit is installed in the rack:
. Use the specified rack mounting kit.
. Be careful not to put your hand or finger in the rack
mount rail.
. Install in a stable posture.
B 4x6
Rack bracket
Rack bracket
B 4x6
B 4x6
Rail portion