Filter
Top Products
Removing, Installing, and Replacing Components
39
Installing a 3.5-inch Internal Hard Disk Drive
Models that have only one hard disk drive have an available bay to hold
an additional 3.5-inch hard disk drive. The drive you install must not
require front panel access. Your system can support ATA-33, ATA-66 or
ATA-100 hard disk drives. Sony recommends an ATA-100 hard disk drive
to take full advantage of the system's features. The hard disk drive access
light blinks when either internal drive is active.
1 Configure the jumpers on the new drive as a slave device (see your
drive’s documentation for configuration instructions).
2 Remove the side cover (see “Removing the Side Cover” on page 24).
! Before opening the system unit, save and close all open files, exit all open
applications, turn off the power to all attached peripheral devices, shut
down the computer, and unplug the power cord.
Power
connector
Jumpers
Drive
connector