Filter
Top Products
40
• The network is not ready
c Check whether all cables are plugged properly into the network connectors. If a hub or router is
used, check whether the hub or router is receiving power.
z Hints
• If a computer on the network configured to share media content does not appear on the “Select a
server...” screen, refresh the server list by pressing the OPTIONS button to bring up the Options menu,
selecting “Refresh”, and pressing the SELECT button. Some time may be required for the computer to
appear on the list. If the computer does not appear after the server list has been refreshed, the Network
Media Receiver may not be configured with the proper IP address. If necessary, change the IP address
allocation setting of the Network Media Receiver to match the system environment (page 33).
• To call up the “Select a server...” screen from another screen, press the TOP button on the remote
control to bring up the Content list screen, and then press the RETURN button on the remote control.
To select a server
Use the V/v buttons to select the server with the desired content, and press the SELECT button.
A list of all content on this server that is compatible with the Network Media Receiver appears
(content list).
For information on functions available when this screen is shown, see “Selecting content”
(page 41).
To refresh the server list
If a server computer on the network is turned on after the Network Media Receiver, that server will
not appear on the “Select a server...” screen. In this situation, perform the following steps to update
the “Select a server...” screen.
1 Press the OPTIONS button on the remote control.
The OPTIONS menu appears.
2 Use the V/v buttons to select “Refresh”, and press the SELECT button.
The “Select a server...” screen is updated to show the latest information.