Filter
Top Products
45
nN
Using Your VAIO Computer
Setting up Windows Media Center
The first time you launch Windows Media Center, the setup wizard will pop up. To configure the TV tuner, click Custom
setup and follow the on-screen instructions. In the Optional Setup window, click Configure tuners, TV signal, and Guide,
and follow the on-screen instructions. In the Which Tuners Do You Want to Configure window, select the TV tuner board(s)
you want to configure and do any one of the following:
❑ Select the first TV tuner in the list to configure the top board in your computer.
❑ Select the second TV tuner in the list to configure the bottom board in your computer.
❑ Select both TV tuners in the list if you can to use both tuners (2 RF signal cables needed).
!
When configuring both TV tuners, make sure that both are connected to the same broadcast signal. For example, both TV tuners are connected to the
same DVB-T signal or both are connected to the same analog TV signal.
In case the TV tuner was not configured during the first run of Windows Media Center, you can do this by selecting set up
TV in the TV + Movies section.
When you want to change TV input signal (TV Signal or TV Signal Type) or change location, click settings in the Tasks
section and then click TV.
Note that in this case a new channel scan needs to be done and that the previous channel list and Guide information is lost
and that scheduled timer recordings are cancelled.