Filter
Top Products
Projecting 13
You can also use the buttons on the control panel with the same names as
those on the remote commander to operate the projector.
1 Press down the MAIN POWER switch of the projector (O ON).
2 Turn on the power by pressing the 1/u (power on/standby) button.
3 Turn on the connected equipment.
4 Press the INPUT SELECT button to select the input signal to be
projected.
VIDEO: to select the signal input from the VIDEO IN VIDEO
connector
S VIDEO: to select the signal input from the VIDEO IN S VIDEO
connector
INPUT A: to select the signal input from the INPUT A connectors
To project the RGB or component signal, press the PAGE button
until the SYSTEM PRESET display appears. Press the V or v
button to select INPUT A and select RGB or COMPONENT with
the B or b button.
MUTING
INPUT SELECT
PIC
VIDEO
S VIDEO INPUT A
TEST
R CENT B CENT
PAGE
M SEL
ASPECT
RESET
1
4
2
Projecting
PIC MUTING button
ASPECT button