Filter
Top Products
18
Location and Function of Controls (Main Unit)
a LAMP/COVER indicators
Flashes in orange under the following
conditions:
• A repetition rate of 2 flashes when the
lamp cover is not secured firmly.
• A repetition rate of 3 flashes when the
lamp has reached the end of its life or
reaches a high temperature.
For details, see page 54.
b ?/1 (On/Standby) key
Turns on the projector when it is in
standby mode. When you press ?/1 key,
this key flashes in green and then lights
in green when the projector is ready to
operate.
To turn off the power, press the ?/1 key
twice according to the message or hold
the ?/1 key for about two seconds.
?/1 key lights up or flashes under the
following conditions:
– Lights in red when the AC power cord
is plugged into a wall outlet. Once the
projector is in standby mode, you can
turn it on with the ?/1 key.
– Flashes in red when the internal
temperature is high or the electrical
system has failed.
– Lights in green when the projector is
turned on, and when it is ready to
operate.
– Flashes in green from the time when
the projector is turned on until the
projector is ready to operate. Also,
flashes in green while the cooling fan
is running after the power is turned off
with the ?/1 key. The fan runs for
about 90 seconds after the power is
turned off.
– Lights in orange when the power
saving mode is on.
For details, see page 54.
c INPUT key
Select the input signal. Each time you
press the key the input signal switches.
d MENU key
Displays the on-screen menu. Press
again to clear the menu.
e PIC MUTING key
Cuts off the picture. Press again to
restore the picture.
f Rear remote control detector
g AUTO FOCUS key
Adjusts the picture focus automatically.
h ZOOM/FOCUS key
Each time this key is pressed, ZOOM
and FOCUS adjusting menus are
displayed alternately. Use the arrow keys
Control Panel
76 8 95432 q;1
Rear