Filter
Top Products
28
The projector incorporates a 3D Sync Transmitter. Depending on the installation
environment of the projector, the 3D glasses may not received 3D signals properly from
the projector’s built-in 3D Sync Transmitter. In this case, connect an optional TMR-PJ1
3D Sync Transmitter and place it near your viewing position.
Tip
Place the optional TMR-PJ1 3D Sync Transmitter directly facing the 3D glasses. Also, in order to
stabilize operation of the 3D glasses, it is recommended that you place the 3D Sync Transmitter near
your viewing position.
CAUTION
Be sure to use straight-type LAN cable of up to 15 m labeled TYPE CM, and do not use
an extension cord.
• The 3D SYNC connector is dedicated for the optional 3D Sync Transmitter. Do not connect
computers or other network devices, to avoid malfunction.
• Be sure to use straight-type LAN cable (not supplied) labeled Cat-7 (Category 7). If you use other
than the specified cable, the 3D Sync Transmitter may occasionally not work.
• Be sure to use cable of up to 15 m, and do not use an extension cord. Also, keep the LAN cable
away from any AC power cords as much as possible.
• Up to one TMR-PJ1 can be connected to a projector. Never connect multiple TMR-PJ1 units,
which may cause a malfunction.
• When connected to the TMR-PJ1, the built-in 3D Sync Transmitter feature of the projector will
automatically turn off. You cannot use both at the same time.
Connecting to an Optional TMR-PJ1 3D Sync Transmitter
Notes
Right side of the projector
TMR-PJ1 3D Sync Transmitter
(not supplied)
LAN cable (not supplied)
: 3D sync signal flow
2 m
(6.6 ft)