Filter
Top Products
112
The sound and everything else works fine except that the line-in and
microphone do not work. What is wrong?
1. Please go to sound properties and check if the line-in and microphone
in are enabled and not muted.
2. Check if the Microphone is ok.
3. When using 6 speakers the line-in and microphone channels are used
for rear, center and bass. 6-Channel audio and microphone/line-in can
not be used at the same time.
Hard disk/FDD/ CD-ROM issue
My Western digital HDD is not detected during boot-up.
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not.
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the
peripherals. If your system has other peripherals connected, like
CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer, I get "floppy boot failure" and the
LED on the floppy stays on.
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive
side (don't trust the "key lock" or "notch") and use the end-connector of the
cable (don't use middle one).
LAN Issues
During LAN driver installation, the system hangs on 75%, why?
Enable the onboard LAN in the BIOS setup.
I have problem installing Novell NetWare v.50.
Disable the APIC option in the BIOS.
For updated FAQs, please check
http://www.soyousa.com/support/