Filter
Top Products
SY-6IEM
Quick Start Guide
8
Hardware
Installation
Step 3. Configure Memory
Your board comes with two DIMM sockets, providing support for up to 256MB of main
memory using DIMM modules from 8MB to 128MB with no restriction on memory
configuration. Therefore, you can install memory modules in any combination.
Memory Configuration
DIMM Banks
MEMORY
CONFIGURATION
DIMM 1 DIMM 2
RAM Type
EDO/SDRAM EDO/SDRAM
RAM Module Size (MB) 8/16/32/64/128 8/16/32/64/128
Note : There are two types of EDO DIMM modules with different operating voltages:
3.3V and 5.0V. Please note that only 3.3V EDO DIMM modules can be used
on this mainboard.
Step 4. Set the CPU Frequency
You do not need to set any jumper for the CPU frequency. Instead, CPU settings are
changed through the BIOS
[SOYO COMBO SETUP].
Please refer to Chapter 3 - Quick
BIOS Setup for details on how to set the Pentium
®
II processor frequency.
Step 5. Enable/Disable Power-On by PS/2 Keyboard (JP1)
You can choose to enable the Power-On by PS/2 Keyboard function by shorting pin 1-2 on
jumper JP1, otherwise, short pin 2-3 to disable this function.
Support Power-On
by Keyboard
Enable Disable
JP1 Setting
Enable Power-On
by PS/2 Keyboard
function
(short pin 1-2)
Disable Power-On
by PS/2 Keyboard
function
(short pin 2-3)
Important: When using the Power-On by PS/2 Keyboard function, please make sure
the ATX power supply can take at least 720mA load on the 5V Standby lead (5VSB) to
meet the standard ATX specifications.
2
1
3
2
1
3