Filter
Top Products
Hardware Installation
SY-7ISA+
32
3. Universal Serial Bus USB1/USB2/(USB3, USB4)
This Motherboard provides four USB ports for your additional devices.
Plug the USB device jack into the available USB connector USB1 or
USB2.
- Standard device drivers come with the Win98 for commonly used
USB devices.
- With Win95, use the flow UHCI specifications. To use USB devices
under Win95, usually you have to install the device that driver comes
with the USB device you have purchased.
USB3 and 4 are available. To make use of these USB ports, purchase a
USB cable from your dealer. The lay-out of USB3 and 4 is as follows:
4. Onboard Serial Port COMA
External peripherals that use serial transmission scheme include:
- serial mouse,
- and modem.
Plug the serial device cables directly into the COM1 9-pin male connector
located at the rear panel of the Motherboard.
5. VGA monitor connector
Plug the monitor cable into the 15-pin female VGA connector located at
the real panel of the motherboard.
6. Onboard Joystick port/audio
This Motherboard provides Joystick port and audio.
- Attach the joystick cable to the 15-pin JOYSTICK port at the rear
panel of you motherboard.
1
9
2
10
3
5
7
4
6
8
GND
(+)Data
(-)Data
Power
GND
GND
(+)Data
(-)Data
Power
(USB4) (USB3)