Filter
Top Products
SY-KT333 DRAGON Lite Quick Start Guide
14
Installation
CMOS Clear (JP5)
In some cases the CMOS memory may contain wrong data, follow the steps below to clear the CMOS
memory.
1. Put the jumper back to 1-2 to allow writing of new data into the CMOS memory.
2. Clear the CMOS memory by momentarily shorting pin 2-3 on jumper JP5. This jumper can be
easily identified by its white cap.
CMOS Clearing Retain CMOS Data Clear CMOS Data
JP5 Setting
Short pin 1-2 to retain
new settings
Short pin 2-3 for
at least 5 seconds to
clear the CMOS
Note: You must unplug the ATX power cable from the ATX power connector when
performing the CMOS Clear operation.
Audio Speakers connections
When using 2 channel speaker, connect the speaker cable to line-out.
If you’re using 4 channel speaker, connect the front L/R speakers to line-out and rear L/R speakers to
Line-in. make sure to set the audio software for 4 channel speaker system.
123
123
Line-out Line-in