Filter
Top Products
Silicon Image Serial ATA Driver Installation
SY-KT600 DRAGON Ultra
106
Chapter 7
Silicon Image Serial ATA Driver Installation
You can use your Sil3112 as
1. Normal IDE function.
2. RAID function. (RAID0, 1)
To use SATA3 and SATA4 as normal IDE, please do the following steps
1. Go to the CMOS setup SOYO COMBO Feature set the
“SATA3,4” to enable.
2. Install the Sil3112 driver, see driver installation instruction below.
To use SATA3 and SATA4 as RAID controller, please do the following
steps
1. Go to the CMOS setup SOYO COMBO Feature Onboard
Device and set the “Onboard SATA 3,4” to “Enable”.
2. Go to the CMOS setup SOYO COMBO Feature and set the
“First Boot Device” to “SCSI”.
3. Set the “RAID/ATA & SCSI Boot Order” to “SATA3,4,
SCSI,SATA1,2”.
4. Press “Ctrl+S” or F4 when the Silicon Image BIOS summary
screen appears.
5. Create RAID set, check appendix A for more info on creating
RAID set.
To boot from the Sil3112 controller, (SATA3 or SATA4)
1. Go to the CMOS setup Advance BIOS Feature and set the
First Boot Device to “SCSI”.
2. Set the “Other Device Boot Order” to ““SATA3,4, SCSI,SATA1,2””.
For more information on the Silicon Image Utility Software, please check
the SATA RAID manual located in “d:\doc” folder in the SOYO driver CD.