Filter
Top Products
VEHICLE INSTALLATION
15
Volkswagen
Make sure you have your radio’s theft protection code before you attempt installation.
When you reconnect power to the battery, you will need to enter this code. Information
about the theft protection code can be found in your vehicle’s audio operation manual.
Before connecting any cables to the black box you must set the dip switch to the VW
position. If you set the dip-switches after you have connected cables to the box, you must
disconnect and reconnect them for the IPOD2CAR to operate.
There are two different cables for Volkswagen vehicles. One cable is for pre-wired
vehicles with the CD Changer connection in the trunk (VW-TRUNK). The other is
for direct connection behind the radio (VW-FRONT).
If IPOD2CAR is not being recognized, sound is noisy and/or Keys on radio not
properly working please Disconnect Ipod2car adapter from trunk, and plug to
radio using VW front cable directly to radio
Cause: VW prewired cable to trunk not shielded and is causisng noise from
IPOD2CAR datalines, into audio lines
Switch to the IPOD2CAR ADAPTER by pressing the
“CD” button on the radio.
To change tracks simply press “Seek <” or “Seek >”
SETTINGS
FOR ALL VW’S
1 2 3 4 5 6 7 8
ON OFF OFF OFF OFF OFF OFF ON
OPERATION
If you use the VW-FRONT cable make sure you connect the black and white cable to ground