Filter
Top Products
ADJUSTING THE PRINTING GAP
The distance between the print head and the platen can be adjusted to
accommodate different paper thicknesses. To make this adjustment, remove
the top cover. The adjustment lever is located near the right end of the paper
bail. Pulling the adjustment lever upwards narrows the gap; pushing it
downwards widens the gap.
There are five positions; you can feel the lever clicking into each position.
The second position from the top is the one most commonly used for single
sheets of paper. Try different positions until you get the best printing results.
Figure 7-16. Adjusting for different thicknesses of paper
18