Star Micronics TCP300II Series Printer User Manual


 
33
• Expansion starting Y address parameter
Specifies whether to expand the registered image Y address to the rasterized image register
buffer
. Becomes 0 when omitted. Specify in bytes (8 dot units). When making minute
adjustments to the image print position in the Y direction, adjust the top and bottom margins
on the image data.
‘0’ to “39”
• Expansion image data parameter
Expresses each 8 dots using two characters of text.
LSB specifies the upper side bits; MSB specifies the lower side bits. In the example below,
this is “3A.” The maximum value that can be specified for image data is 1024 bytes (512 x 8
dots).
The number of image data should be an integer magnification of the image length.
bit 0 ‘3’ (33h)
bit 1
Ο bit 2
Ο bit 3
Ο bt 4 ‘A’ (41h)
bit 5
Ο bit 6
bit 7
If using a card in the vertical direction (portrait), you should rotate the original print data
beforehand.
*1: The following equation is for the number of times to repeat the command (when the
image data count is an integer magnification of the data length).
Repeat count = X direction dot count/(image data count/data length)
Y Coordinate
Repeat count
*1
Data Length
X Coordinate