Filter
Top Products
DE100i-A100 User's Guide - Rev. C02 StorCase Technology, Inc.
Installation 9
InstallingtheReceivingFrame
The drive should be installed into the carrier before installing the receiving frame into the
mounting bay of a computer or expansion chassis.
NOTE: Use a #2 Phillips screwdriver for this procedure.
1. Turn OFF power to the computer.
2. Open the computer system according to the manufacturers instructions. If neces-
sary, temporarily remove any expansion boards that may make installation difficult.
3. Select the Master/Slave configuration on the rear of the receiving frame by placing
a jumper on the appropriate (J5) pins (Figure 8). Remove the jumper if you wish
to use the Unit ID Select switch on the receiving frame to configure the Master/Slave
drive selection. Refer to Table 1 for further information.
NOTE: The unit ID select switch configures the unit ID display only. The
master/slave setting on must still be set on the drive itself (refer to the
drive manufacturer's documentation for further information).
0423A
Slave Drive Select
Master Drive Select
(Factory Default)
J5
4. With the drive carrier locked in place inside the receiving frame, install the
DE100i-A100 into the 5.25 drive opening in the computer or expansion chassis. Use
the appropriate guides to position the Data Express, and fasten it into place with the
four (4) #6-32 Phillips screws provided. Figure 9 illustrates the location of the
mounting holes. Mounting holes are provided on each side and the bottom of the
receiving frame to accommodate a variety of mounting configurations. Use the
mounting holes which best suit the computer or expansion chassis configuration.
Note that bottom mounting holes require self-tapping screws (not provided).
5. Adjust the front of the receiving frame so the carrier slides freely in and out on the
receiving frame guides. The position of adjoining peripheral units may require ad-
justment.
Figure 8: Master/Slave Configuration Jumper J5