Filter
Top Products
Powering the System On and Off 3-7
3
Figure 3-4 CPU Reset Switch on the Clock Board
3.2.2 Reading Boot Messages
Use the boot software messages to verify that all options are installed and
recognized by the system. After firmware completes the system self test, a
message similar to the following will appear on your screen. The message lists
hardware detected in the system.
Note – This screen display is an example only. The actual message displayed
on the screen will vary with the software running on the system.
If firmware indicates a hardware problem at this time, refer to the
Ultra Enterprise 6000/5000/4000 Systems Manual, Part 3, “Troubleshooting,” for
further instructions.
16-slot Ultra Enterprise 6000, Keyboard Present
OpenBoot -.- FCS, --- MB memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
CPU
reset switch
System
reset switch