Filter
Top Products
32 Sun Dual 10GbE SFP+ PCIe ExpressModule User’s Guide • August 2008
11. Click Subnet Mask.
The value 255.255.255.0 is displayed.
12. Click OK.
13. Repeat Step 3 through Step 10 until all the network ports are VLAN configured.
Note – Ensure that the firewall is configured to allow VLAN traffic. Otherwise, the
VLAN might not operate properly.
Configuring Bonding for Multiple
Interfaces
▼ To Configure Bonding for Multiple ixgbe
Interfaces
1. Use the modprobe command to configure the mode:
In this command,
■ max_bonds is the number of bond interfaces to be created.
■ mode specifies the bonding policy. (This example uses balance-rr.)
2. Use the ifconfig command to create the bond:
In this command bond0 is the bonding device.
3. Configure the bondn interfaces.
# modprobe bonding mode=balance-rr miimon=100 max_bonds=1
# ifconfig bond0 192.2.2.15 netmask 255.255.255.0 broadcast 192.2.2.255
# ifenslave bond0 eth4 eth5