Filter
Top Products
Appendix D Installing the Sun 10-Gigabit Ethernet Device Driver on Linux Platforms 57
▼ To Set ixge Parameters in a Linux Environment
1. Remove the Sun 10-Gigabit Ethernet PCI-X device driver, if it is already loaded.
2. Load the Sun 10-Gigabit Ethernet PCI-X device driver:
or you can use the insmod command:
where VAL1 applies to the first ixge interface and VAL2 to the next interface and so
on.
# rmmod ixge
# modprobe ixge option=VAL1, VAL2, . . .
# insmod ixge option=VAL1, VAL2, . . .